- When removing the rear door panel, note the tab you have to depress to pull the plug out
- This is the diameter of the speaker cut out in the door. About 5 1/16".
- Here's the distance between the two lower speaker frame screw points.About 5 5/8". The distance to the other hole above these was further than my 6" caliper could reach.
- Here's a straight on shot of the door with speaker removed. Notice the contours of the door panel. Sealing between the spacer and the door is going to be a challenge.
- Here's a side shot of the spacer mated to the door. Note the large gap that we'll have to seal.
- I believe that gap is about 1/4". I think I'm going to add foam gasket from both the door and the spacer.
Saturday, August 24, 2013
Other rear door pictures
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment